Hello,
I am using R30iB controler with M10iA robot.
I recieved chandged IMG files from Fanuc with additional ProfiSafe software. After I did image restore, the teach pendant ask for apply DCS. So I did. And now, after power cycle the teach pendant wont start.
It shows, first boot messages, then even gray window saying **Preparing system**, one white flash and it stays black. Controller is running, 4leds green, no number on the led display.
So I restore the image again and the pendant work, after apply DCS it reboots. Then I had to bypass profisafe, becouse we dont have conn with PLC yet. So I apply DCS again, but after that, the pendant didnt reboot again. This time it shows Internet Explorer window with "Action aborted" message.
I restored image again and this time I bypass ProfiSafe at first start, but after power cycle the pendant goes black again.
I feel quite unsure what to do, becouse i dont have so much experience with Fanuc.
Have someone any experience with this kind of problem?
Thanks in advance.
//btw. no internet or profinet is connected.
//I realized this thing after another try. After DCS power cycle the pendant almost start, it writes "acces acepted" and i saw a screen for a moment, then the controller restart itself and it go to black.