Hello Robot-Forumers,
I have a 2006 model of Fanuc I am powering up for the first time in a long time. I am not sure if any jumper wires were taken for other projects. On my servo axis board, I have a 3 wire cable plugged into CRR63A, but there is nothing plugged into CRR63B. Is this the correct configuration for regen resistors?
I currently get DCAL errors for G1 Axis1 and G1 Axis2.
Tomorrow I will work at the suggestions.
Decrease run speed
Look at CRR43 and CRR45
Replace Servo Drive
Check Cabinet fan running/dirty
CRR45 on main board
Any other ideas to check?
Thanks, Del