Does anyone know where I can find step by step on changing one of these boards out?
Kawasaki AD controller 9za board
-
hugent -
September 22, 2016 at 4:23 PM -
Thread is marked as Resolved.
-
-
Been toooo long since I have used one of these......as far as procedures go, I don't know but:
9ZA contains the AS/SV Eproms/Battery etc.
- So, I think you would need to swap the Eproms over to the new board, confirm jumpers and switch settings (I think maybe SW3) are the same as old one.
- Make sure the fitted batteries have some juice in them.
- Power up with SW3 no.8 ON in order to initialize it and then load up a previous backup using Aux 11 Floppy drive etc.
- When completed, power off, turn off SW3 No. 8 and power back on again.Not sure if this is correct or not.......