Hello Sir.
I have a OTC EX robot. when i turn power on teaching pandent is everything ok. And i turn on servo it can not work and no error on teaching pendant.
please help
thank you.
EX robot can not turn on servo
-
Harryusjp -
September 13, 2016 at 10:53 AM -
Thread is marked as Resolved.
-
-
Hi,
the Stop circuit is dual , one set of contacts allows "Servo power On" , the other is "Servo Enable"
which is the Contractor / Relay (base of cabinet , right hand side) . This contractor must be pulled in.
Note - because the Servo Power circuit might be OK , you will have no error display.
Check that BOTH wiring circuits are OK and no broken wires and bad contacts etc. are present. -
Thank you sir.