i have tried to reset the pass word per the insrtuctions for reseting the password. i get to the part where i am to "cursor down so that passclr.sv file is highlighted. however i do not see the "passclr.sv to highlight. it is not there.
IMSTP ERROR
-
Dean -
September 6, 2016 at 2:24 PM -
Thread is marked as Resolved.
-
-
Hey.. i have this problem too, and I solved:
Hold is RED and IMSTP ERROR CALLING
STEPS:
1 - press MENU button
2 - press "0" (to go next page menu)
3 - select "SYSTEM" and press ENTER
4 - hit F1 and select "VARIABLES" and press ENTER
5 - scroll down to $OPWORK and press ENTER
6 - scroll to $UOP_DISABLE
7 - change the value to "1" and press enterObs: the robot will no longer run in an automatic mode with UOP control until the value is changed back to "0"
But, after remove error I take zero position in manual, reset commands and change to 0 UOP CONTROL
WORKED FOR ME !! SORRY ABOUT MY ENGLISH !!
By Beto Presuntinho RIO CLARO - SP, BRASIL
Whirlpool S.A.
-