Hello all
I am using cc-link protocol for communication. Plc is my master , robot ( r30ib mate) is my slave. Suddenly an error got triggered in robot. " prio-325 cc-link seq. Cpu stopped". There is no error in the system. Plc working fine ,robot is working fine, even i can able to communicate & exchange I/o between robot and plc. But I am getting an error in robot, I'm not able to reset the alarm. why it's happening??
Help CC-Link issue
-
suganthyadav -
August 5, 2016 at 1:23 PM -
Thread is marked as Resolved.
-
-
From my edoc cd:
Cause: The sequencer CPU stopped.Remedy: Confirm the status of the sequencer. Please note that this alarm is detected correctly only
while the robot Remote Device station is exchanging data with the Master station. -
Dear cobenson
But sequencer cpu is running fine. PFA
Confirm the status of the sequencer. -
Hello
CC-Link setup
SETUP CC-Link
3. Baudrate : [ 156Kbps]CC-Link Cabling Photo verified