I have a dx100 that had the cable to axis 3 pulse coder break. I have replaced it to only have the break release and the servo drops causing travel in wrong direction alarm please help if you have any ideas
DX100 need help!!!!!
-
plunkett.phil -
February 29, 2016 at 5:25 PM -
Thread is marked as Resolved.
-
-
Sounds like the arrows aren't lined up. If you remove the encoder and look at side that goes to the motor about halfway the black piece on one side is an arrow (triangle). On the motor side if you look at the shiny piece about halfway down one side is an arrow (triangle). These two arrows need to line up.