We have a Fanuc RJ3iB Robot that was a wire feed wire welding cell. I am in the procces of repdoing the cell with a plasma torch and was wonding if anyone know how to configure the robot to not have the Acrlink card. The Arc Link card is in slot 3 right now and the robot works fine just always has the Arc-45 warining.
ARC Link Card
-
jseavers -
January 22, 2016 at 7:58 PM -
Thread is marked as Resolved.
-
-
Ended up reloading the software from the MC card and not having the Arc Link card installed so it could not auto config the I/O