I have an ABB IRB6650 S4+ and it is asking for P-Start every time we restart. It says it have unsaved modules. If you try to save any program, it will say that some of the modules couldn't be saved. Not sure what it going on. This robot was running ok couple of weeks ago. Any help would be appreciated. Thanks
ABB IRB6650 S4+ asking for P-Start
-
taganini -
January 21, 2016 at 7:05 PM -
Thread is marked as Resolved.
-
-
Hi taganini.....
When I have this message I do this:
Go to menú see
Select modules
Select module unsaved
Push archive menu
Select saveDo this with each of a unsaved modules...
I tope this action will be good[emoji1]
Enviado desde mi bq Edison 2 Quad Core mediante Tapatalk
-
Thanks for your tip... but I can't find this menu you are talking about..is that on the Programming Menu??