I have an arcmate 100ic
I haven't worked much with mapping variable data to registers.
I am trying to do the following -
1: GO[1]=($aweanlg[1].$amps) ;
2: GO[2]=($aweanlg[1].$volts) ;
3: GO[3]=($aweanlg[1].$wfs) ;
4: GO[4]=($aweanlg[2].$amps) ;
5: GO[5]=($aweanlg[2].$volts) ;
6: GO[6]=($aweanlg[2].$wfs) ;
But when I try to execut the program I get fault INTP 254, parameter not found.
I also tried...
$AWEANLG[1].$AMPS.$AVERAGE
$AWEANLG[1].$VOLTS.$AVERAGE
$AWEANLG[1].$WFS.$AVERAGE
Same problem... does this just mean these variables don't exist?
If so, does anyone know the variable name I'm looking for?
it did work when I used...
1: GO[1]=($awepor[1].$amps_fdbk) ;
2: GO[2]=($awepor[1].$volts_fdbk) ;
3: GO[3]=($awepor[1].$wfs_fdbk) ;
4: GO[4]=($awepor[2].$amps_fdbk) ;
5: GO[5]=($awepor[2].$volts_fdbk) ;
6: GO[6]=($awepor[2].$wfs_fdbk) ;
But the data that I got back didn't match what I see on the OTF screen on the TP
Thanks...