Hello,
I'm in need for more than the 10 available touch skip schedules that comes with the option. I have tried to find these schedules in the system variables but with no success. My idea was to create a Karel program that could write to these schedules and give the possibility to use the same schedule with different values depending on the TP programs.
Does anyone know anything about what options i have in this case? So far Fanuc has not been able to give me an answer on this question.
Expanding number of Touch Skip Schedules?
-
ThePainter -
March 3, 2015 at 2:21 PM -
Thread is marked as Resolved.
-
-
I never use this option as I just do it myself through the TP, but try doing a controlled start and going under the maintenance and I think it is program control. this is where you can open up user alarms PR's etc. hopefully it has an option for this if touch skip is turned on.
-
I never use this option as I just do it myself through the TP, but try doing a controlled start and going under the maintenance and I think it is program control. this is where you can open up user alarms PR's etc. hopefully it has an option for this if touch skip is turned on.I have tried to find it under controlled start but there is no such setting. Would it be possible for you to share some code that you are using to do this without the option or system variabels that i can use to achieve the same result? Thank you!
-
For information: Got an answer from FANUC regarding the touch skip schedules. They can be found under the system parameter $MISC_SCD. Maybe this could be of use for someone in the future.