We just installed a our new Fanuc 100i robot and got it wired up. When trying to boot it up, we get "Loading uncompressed data" and then "Checksum ED06955F" and then the screen goes blank. Have tried to do a controlled start, and still get a blank screen. We have tried using a different TP and cable from our other 100i and still the same problem. Have tried searching and can't find anything on that Checksum. I've been looking through all our books, and can't seem to find anything either. Any input and suggestion welcome. If I need to provide anymore information, just ask. Thank you.
Checksum ED06955FF
-
mtmfab -
December 5, 2014 at 6:01 PM -
Thread is marked as Resolved.
-
-
What model controller?
-
1998 or 1999 rj2 with arctool 4.30b and I cabinet computer control..
This robot is brand new, never installed before and we were lucky enough to get it very reasonable.
We already have one just like it running in our shop.
Thank you. -
Usually this indicates the software has crashed and needs to be reloaded.
-
Now how do we do that? We've never done that before and don't know where to begin looking on how to.
-
Not real hard but a manual is more than helpful here. You need a floppy drive or Kfloppy emulation software and all of your floppy disks.
-
Looks like we're on the right track then. We have a gentleman taking a 7 hour trip down to help us with this. Looks like we identified the problem without knowing we did. We don't understand the manual on how to install the software, nor do we understand emulation. We have all the books/manuals and floppy disks that came with the robot. Hopefully we get this figured out tomorrow!
-
Not real hard but a manual is more than helpful here. You need a floppy drive or Kfloppy emulation software and all of your floppy disks.
Hi Racermike123;
I have a robot me the same problem. I can install a memory card of 2MB. There are employees of the same robot smoothly. I can get to the system from running the software in another system. If you could help, I'd appreciate it. My robots RJ2.. -
I have KFloppy. But I dont know F-ROM get into the computer with KFloppy. And INSTALL agaın?
-
DO you have the robot software?
-
I don't have robot software. Can I copy from another robot?
-
The robot is currently on a screenshot.