Someone told me if you change the program of a Fanuc robot, that somewhere an autogenerated code will change
that the CE-aprovement of the machine has to be redone?
I can hardly believe this, but just to be sure, could this be true or not?
CE-aprovement
-
Plc_User -
December 4, 2014 at 9:35 PM -
Thread is marked as Resolved.
-
-
As i know, not exactly,
You probably talk about recent controller with DCS software.
In the DCS menu, there is a lot of setup/monitoring that should be validate (ex.: changing TCP, Userframe, Masterdata, etc....) that will pops-up a flag and aske you to confirm the changes.
When this is done (that request a password), the controller will generate a kind of checksum code that is the signature of the change.Each time a change is done, that code change also.
Usually, a register book of those codes should be done and signed (and dated) by the person who made changes and validate them.
Hope helping a bit !
-
Attached is the summary.dg file,
the controler type should be M-710iC/70?
Is this the kind of controller that creates the checksummes after changements?
But after all, changing code in the Fanuc, could that lead to a new approvement of CE-label?