Hello everybody! I really need some help with some comms I've been doing between Siemens PLC Profinet->Anybus-X->Fanuc M-710i.
Previously, we've been setting the comms by means of Profibus being the bot one more slave of the PLC. I have clear all this previous comms and only using the rack 89 for the IO assignments. As describe in the link below with a Anybus-x slave in both sides of the network, we've tried to set the ethernet/IP net:
https://www.robot-forum.com/robotforum/fan…emens-ethernet/
Main problem is when I set up the scanner configuration for the anybus because I'm receiving two warnings PRIO-350 and PRIO-358 (0x116 minor or major revision are wrong). I've checked the EDS file that came with the anybus in order to find if the software version is the same that was updated to the device when was setup. The version is the latest from the HMS website, v2.07 (previously was the v1.9).
The config so far is this:
----------------------------
Scanner configuration
----------------------------
Description: HMS Anybus-S Ethernet/IP
Name/IP address: 192.168.1.7
Vendor ID: 90
Device Type: 12
Product: code:14
Input size (bytes): 64
Output size (bytes): 64
RPI (ms): 32
Assembly instance (input): 103 (using slot 3)
Assembly instance (output): 153 (using slot 3)
Configuration instance: 100
-------------------------------
Advanced configuration:
-------------------------------
General
I/O Data Type: 8-BIT BYTES
Timeout Multiplier: 4
Reconnect: FALSE
Major revision: 2
Minor Revision: 14
Alarm severity: WARN
Quick connect: FALSE
Originator to target
RPI:32
Target to originator
Transport type: UNICAST
RPI:32
Connection Type
Type: exclusive-owner
0=>T format: Run/Idle Header
T=>0 format: Modeless
Configuration String Status
Size (bytes): 0
By the way, I've used Port 2 and Port 1 for Ethernet/ip and same problems happened. Possibly the minor and major revision are wrong but I wouldn't rule out any other problem during configuration.
Does anyone have a solution?
Thanks in advance.