Hi all, first post!
I have a robot cell modelled in Delmia with an end effector attached which has a tcp about 200mm away from the flange.
I'm trying to setup a parametric line from a fixed point inside said simulated robot cell to the tcp of a loaded tool. The line will simulate a laser line and enable the line of sight to be checked during simulation of a robot task. I've tried a couple of things like creating a new product linked to the end effector as parent-child but can't figure anything out.
Any experiences or successes in something similar would be greatly appreciated.
I'm partially into vb so if someone thinks this is the only way I'll give anything a go!!
Cheers