Hello
Does anybody know how to reset the encoders on a NACH SC35F -01 ?
Saw it for different model on youtube, but on my the cable terminals are different. see picture
Thanks a lot
Hello
Does anybody know how to reset the encoders on a NACH SC35F -01 ?
Saw it for different model on youtube, but on my the cable terminals are different. see picture
Thanks a lot
check attached
Thanks to bsrr the encoders are resetted, but machine is still not moving, when trying to move it, it gives an error : E0121 - E0128 software limit exceeded.
Do i have to tell the encoders their home position ? How do i move the axes to their home position, assuming i know where they are ?
Thank you so much out there !
You need to carry out Encoder Correction to fix this problem
Procedure for Encoder Reset and Encoder Correction
1. At first Insert the Zeroing Pins for each axis and carryout encoder reset
2.Power off and then On
3.Constant-Machine Constant -Encoder Correction-Record pos--Enter Key and then Complete Key
Hi bsrr
Kind of stepped over it accidentally,:
made this encoder reset by shorting the wires again on the pin position, but didn't change the position values.
then i zeroed the encoders with encoder correction. now it seems to work.
would have thought that the encoders go to zero when doing the reset.