Hi all,
i got an NX100-controller and have encoountered a weird problem with it after creating a new userframe.
Have succesfully made the userframe for my jig and the tip of the tool follows nicely the path on the so called " origo - line " ORG-->XX-->XY. But for example i move the line 40mm on the Y-direction from the origo line the pointer starts moving on its own world. If I then start linearly going on the XX-direction 1000mm in the end of the path the tool goes 2 mm also on the XY-direction. And when i move it further from the origo line the difference just gets bigger. Roughly 500 mm from the origo-line on the XY-direction the difference on the XX-direction is already 4 mm...
Any ideas what could be the solution for this ?
thanks in advance,
Kauko