The title says it all...
We have the touch screen system for a customer and we would like the "Weld Enabled" to be on by default when the controller start...
Any BGLOGIC or command I could use?
Thank you
The title says it all...
We have the touch screen system for a customer and we would like the "Weld Enabled" to be on by default when the controller start...
Any BGLOGIC or command I could use?
Thank you
Need controller version and software level
R30iB
8.20p/10
If I'm not mistaken
On my Arcmate 120 iB's I use:
$AWEPOR[1].$ARC_ENABLE=1
on the first line of my program (followed by an Override 100%)
This is the system variable that controls the welder. (You could also do some BG Logic that turns it on automatically whenever Auto is enabled)
Thank you very much, I had found the variable but for some reason I was trying to put =ON instead of the =1....
Thanks again