Hey guys is it possible to call a job from a jet table and run it as a subroutine? I've previously used the syntax CALL JET#(1) ENTRY=PProductNumber to call a JET table job so I was thinking PSTART JET#(1) ENTRY=PProductNumber SUB1 would get me there. Any suggestions?
PSTART from a JET table?
-
JZiesmer -
January 17, 2014 at 9:28 PM -
Thread is marked as Resolved.
-
-
From what I've seen, the PSTART instruction doesn't allow a JET tag directly on it. Get creative PSTART a non group job and within it CALL JET#(xxx).