I'm trying to eliminate using conveyor tracking for a pick and place application, but still use the vision system (Cognex with EasyBuilder and PatMax). The roadblock I have is how to set up picking parts from our 12X12 inch FOV directly under the camera. I still need to know the X Y and Theta of the part without looking for the the conveyor tracking. How would I do this with an existing job, as I am new to vision guided systems.
Help with picking parts from 12X12 FOV using vision
-
SquizzleT -
November 7, 2013 at 5:03 PM -
Thread is marked as Resolved.
-
-
Figured it out. Had to remove the Adjust statement and do a retrain of the part under the FOV, then create a pick point with no shift.