Hello
Is it advisable to disconnect or reconnect an interbus cable from a KUKA Servo Drive while the controller is running?
Thanks,
Jason
Hello
Is it advisable to disconnect or reconnect an interbus cable from a KUKA Servo Drive while the controller is running?
Thanks,
Jason
Generally it's a bad idea to disconnect servo drives while running!
Why do you need to do it?
Sent using Tapatalk 4.
Thanks Eusty.
Just looking for the quickest way to fault find, one of the drives did not have a stable 24V supply, the LED's would go high for a few seconds and then off completely and so forth. I ruled out an unstable input supply, as you know this is looped and the drives before and after the faulty one were ok. I replaced the fauly one with a spare and all was ok.