Ok.
I'm waiting for results of testing.
In hand mode for me You HAVE TO GET drives on with deadman switch pressed on with closed door or when You have opened door with E2 key turned on.
In auto mode there is signal from external control Drive on sooooo if You don't have NOT-AUS and all of ther conditions are checked there is problem inside of cabinet not with KSS - in my opinion.
Marek
KRC1 Problem
-
kukart -
May 6, 2013 at 12:18 AM -
Thread is marked as Resolved.
-
-
Eureka !
I have found the problem. It was Dip Fix 7, 8 and 9 on VFE201 card. However, I have already check that but really it's difficult to see if they are on or off visually.
To resume, the problem was relay K2 in VFE201 card and when I have swap this card I did not check Dip Fix position. (when the card is new this dip fix are Off = for additional axis)
Thank you very much Markopo for your Eplan, without you I would not have found the fault.
Thank you too Skyefire for your help.
Now I have to come back with my initial problem "torque exceeded default with all axis...". I going to open new topic for this subject.Kukart
-
kukart.
It' s pleasure for me that my infos brings You closer to resolve problem
Nice to hear it.
What's up with next problem with this trouble-full roboMarek
-