how do change what a programer can do from his login status? or do i change in the varibles? or do i change it off line?
password login
-
rdunham -
March 5, 2013 at 6:28 PM -
Thread is marked as Resolved.
-
-
Are you using RJ-2?
if so;
Press MENUS.
2 Select SETUP.
3 Press F1, [TYPE].
4 Select Passwords.
5 Press F2, USERS
6 Press ENTER. Use the arrow and function keys to type the Install
username. When you are finished, press ENTER.
7 Type the new password and press ENTER.
8 Type the new password again to verify that the first one is correct and
press ENTER.
9 If you want to log in press F4, YES. If you do not want to log in
press F5, NO.
NOTE You must log in as the Install User to enter other users.
10 To assign the next username, move the cursor to the next available
username, press ENTER, and use the function keys to enter the
username.
11 Move the cursor to PWD, press ENTER, and use the function keys to
enter the password.
12 Move the cursor to LEVEL, press F4, [CHOICE], and select a level.
13 Move the cursor TIME and type a Default User Timeout value. You
can adjust the Default User Timeout value from 0 to 10080 minutes
(seven days).
NOTE If the Default User Timeout value is 0 when you log in, a timeout
will not occur.
14 Repeat Steps 10 through 13 for each user you want to have access to
the system.
15 To clear the current username and password, press NEXT, >, and
then press F2, CLEAR.