Yes, I01 works. Thanks.
Posts by fisher
-
-
Thanks a lot.
It works.
The command ioboard_status still cannot find any board. But the input signal can be read by bits function now.
I have been stuck here for a month. I really appreciate it.
Thank you again.
-
Yes. I got it.
Sorry, I am slow.
Thanks.
-
It was the settings when I got it. I don't know how to disable it.
-
I think you need to disable KLOGIC option then.
Why is this enabled if you're not going to use it, this is an option and not enabled as standard.
Check your conversation,...........I have sent you procedure to disable it.I could not find the procedure to disable KLOGIC option. Could you send it to me again?
-
To be clear:
- You are only using a 1TW board and no 1UR board (this is removed yes).
- You are not intending on using KLOGIC?
Got it. Sorry I am a newbie. Thanks.
-
To be clear:
- You are only using a 1TW board and no 1UR board (this is removed yes).
- You are not intending on using KLOGIC?
Yes. I am sure.
Thanks.
-
Here is the backup file.
-
-
-
-
-
I don't know how to upload files? Could you give me some instructions?
Thanks.
-
Did what you said.
Aux 0610 settings are set to disable.
I am not using KLOGIC at all. KLogic Settings as below:
Number of Signals between AS<=>KLogic: Changeable according to the number of hard signals
KLogic auto start (AUTOSTART.LSQ): off
Retain the counter value at power off: off
restarted the controller. ioboard_status still cannot find the board.
-
No error on power up.
1TW address set SW1 to ALL OFF.
Aux: 611:
Number of Output Signals 64
Number of Input Signals 64
Number of Internal Signals 256
Aux: 607:
Top Signal No. of Signal
Output Signal 33 8
Input Signal 1033 12
Fieldbus is disabled.
Thanks.
-
-
It is a Kawasaki robot.
-
Our E01 Controller has one 1TW board installed (no 1UR board). But the command IOBOARD_STATUS cannot find the board:
>ioboard_status
IO 1- 16 17- 32 33- 48 49- 64 65- 80 81- 96 97-112 113-128
NON NON NON NON NON NON NON NON
DA 1- 4 5- 8 9- 12 13- 16
NON NON NON NON
I need to use one external input for a proximity sensor.
How can I enable 1TW board in the system?
Thanks a lot.