Thanks my friend,i have already check the switches maby is the cable broken.
Posts by Enio
-
-
Hello everyone.
I have an old ABB M93 S3 controller.This welding robot is configured with two stations external axes. With only one safety sensor protecting the operator during interchange.
I have an issue with the Photoelectric safety sensor. When the robot is welding on station 1 on auto mode and the safety sensor beam is interrupted the motors goes off .It hapend only with the station 1 on robot.
I hope some one help me with this issues
Thanks
-
Hello , thanks for the advise,
Should be any light turn on on the Dsqc 241 board , in the power unit all the lights are red, in the Dsqc 230 board the llights are red to.
-
Hello everyone, I have some problems with an old S3 M93 controller, after power on the led on Dsqc 230 board is turn red ,also the lights in the 2 input board and the sensor board are red,the TP shows "PRog unit communication fault" no LEDs in the dsqcc 241 board are turned on. I try to test mode with the test and init button on the dsqc 230 board but have no results.I am looking for help , how can I diagnose the problem, is there anyone that knows this old robot.Thank you