Hi
Have you tried to upload fresh image from the copy?
Regards
Lupus
Hi
Have you tried to upload fresh image from the copy?
Regards
Lupus
Hi
I know that new robot controller can communicate with Lincoln Power Wave throughout Ethernet. But I'm not sure you'll find relevant option for RJ3. In my case, I have RJ3 and Lincoln Power Wave connected by analog and digital signals. Anyway you need Arctool. Did the Fanuc tell you the price? Write me a PM with your e-mail address.
Hi
What kind of Lincoln: PowerWave or someting else? With Arclink? For 90% RJ3 controller doesn't support Arclink. May be a problem with communication between robot and Lincoln. The second robot model is? Probably is not possible to install Arctool on this robot, because you have to install whole image, not only a part with arctool.
Regards
Hi
In my opinion will be difficult.
First of all:
1. What are you going to weld (material, size, quantity)
2. What kind of welding equipment you have.
3. You should contact to your local Fanuc supplier and ask for arctool, and other programm options. Expensive.
The most important is: what is to welding.
Regards
Lupus83
Hi
What is the difference between servo amplifiers for external axes A06B-6114-H105 and A06B-6117-H105? Theoretically 6114 is an old specification, it fits to RJ3iB system. Can I install it in RJ3iC system?
Regars
Lupus83
Hi
Few days ago, I had similar problem with my old comau. There was information that wrist is without position. On the screen was a view of 6 resolvers value and indeed in last position there was 0. I have disassembled plug inside the servomotor connected to rosolver. I've cleaned it. Works.
Probably you were there:
Hi
Ping works in both directions? Can you load robot webpage on computer?
Regards
Lupus83