Thanks. I will check it tomorrow
Posts by Nix7777
-
-
I have just been pulled off of this machine and placed on a different one to get it up for production. I’ll check the Ethernet when I am able to get back to it. Thanks And I’ll post as soon as I can get back to the trainer.
-
I have stars in place of my status’. If I try to force a bit it says port is not defined. In relation to my pr I’m not getting the robot home input.
-
I’ve walked into someone else’s mess and have to setup a training/parts robot.(Fanuc 100ic) In doing so I’ve seemed to have turned off my direct outputs. I do not know where or how I have done this. The robot functions but I’m unable to use any PR’s at the moment. Any ideas?