Yes this make sense. I tested this before. But i Will do it exactly your way today. I Will let you know what the results are.
Posts by W4e
-
-
I understand that so let start over.
-
Yes the first time i did but then the problem moved too. I tried also the servo boards to swapped but then the problem stayed to the same motor.
-
But i swapped encoders too when i swapped the cables. So you still think igbt? Because the other motor was working fine after slapping the cables
-
I powered the robot off and after that it wont work. The earth leakage circuit breaker switched off to today and yesterday. So maybe there is something more?
-
-
I swapped those 2 kabels. Then the problem Goes from jt4 to jt5
-
Hmm no luck. Same problem. I donβt know where to look. I donβt know how to test encoders? I tested all encoder wires.
When i swap the the kabel between 1ge and servoboard 4 and servo board 5. The problem Goes to motor 5. So the kabel between the 1ge could be a problem or what do you think.
-
Lol newby on the forum he ππ sorry my fault and thanks again.
-
Hmm i look throught the whole thread but i couldnt find it ππ
-
-
-
But is it also possible to download it from the other 1ge and upload it to the new one?
Is that simply by download to floppy and then replace it then upload from floppy?
-
-
Yes correct. But i think i need to reinstall it first?
-
Sorry i understand. I tested more and the conclusion is that the servo power board is ok. So i have an issue in 1ge board. So i want to replace it with the js10 board. I tested the board in the js 10 and was ok. So i want to try to build it inside the js30 can i reinstall it with the same instructions/file as the js10?
-
Yes i thought that too. But i removed it from the board and everything was ok. Then i swapped again the connector then i had problem on other motor again. So must be inside the 1ge our Somewhere in that direction. Can i use js10 1ge board. I tested and was working. But do i use same file to install for js30?
-
I tested a bit more and found out that the error is not come from igbt. But from the 1ge. Is it possible to swap the board? Do i need to reset something
-
Hahaha thanks yes then we have the same thing in mind π
-
I tested it a lot. By multimeter but how can i tested it?