No, I am just calling the Seal Schedule with an SS command, and using an SE command to end it.
I'm not sure how new your software is but I do not believe there is anything like that in the version I am running
No, I am just calling the Seal Schedule with an SS command, and using an SE command to end it.
I'm not sure how new your software is but I do not believe there is anything like that in the version I am running
I am using DispenseTool v4.3 and have a dual equipment setup.
I have tried using all equipment type, I have setup the flow command to output to AO[1] on E1 and AO[2] on E2, both analog outputs are working.
However, when I run a Seal Schedule (both have Seal Schedules setup), only E1 outputs flow command.
Since the program is usually done in the "world" motion mode, I think it is difficult to send the individual speeds of the motors as an analog signal. For this, I think it would be more appropriate to use the " TCP " feature (that is, a center point introduced for the tool used).
I do not believe that DispenseTool v4.21 / 4.4 has the menus in the attached files.
I have an analog output card installed in a FANUC RJ-2 system using DispenseTool v4.21. I was wondering how I would output the current speed of the robot via the analog output card.
Following the manual for DispenseTool v4.21, after installing the 4 application disks, a window asking for the robot model should display (according to the manual). However, a message pops up which says "Insert CORE2 Disk".
We are loading all of these from KFLOPPY.