Thanks a lot for share it
Posts by durpol
-
-
Thanks for your reply TSGIR i am searching the board with my supplier, when i replaced the component i going to inform, thanks in advance.
-
Thanks for you reply. I did replace the battery pack and mastering but power off and power on and lost the calibration.
-
Hello
excuse me i have a yasnac SK10 with mrc controller, in the last year have issue with it, it loss the position and show me in the display defective encoder absolute data code "1260" and another errors, could you someone supportt with the manual for to ask the parts? all tha time we have mastering the robot, we replace ther batteries but no fixed the problem.
thanks in advance
-
Thanks a lot. Now work but the version 3.1 (krc4) is very different to krc2 (2.1), in this version i can´t found the "calib" option (to set the sensor to zero) and the sensor work not well. i must to study the manual more.
best regards
-
hello
Excuse me i have problem with configuration of FTC version 3.1 and KSS 8.3.32 i believe is by ip address.
can you show me your ip address my sensor is ati omega with netbox.
thanks in advance
-
HELLO I SEARCH FANUC ROBOT M10i IN USA, CANADA OR MEXICO.
THANKS IN ADVANCE
-
Hello, excuse me hermann for you external axis, do you need power supply external for the powerin the robot?
Thanks in advance.
-
thank you Skooter.
-
Hello, thanks for share it.
Depend of the version of KSS is how to change the postprocessor.
Will be better if you can shared pictures about the errors showed in the kcp. i can imagine errors about the base frame and about the
initial conditions
best regards
-
Hello again.
ok by the tcp but you need to determinate the direction of the tool.
attached document by powermill
by kuka first is tcp 4 points and after orientation of the vector.
can you tell us what is the program offline
i hope help you
best regards
-
Hello yes the way for to program is easy like motoman. if you have the serial (plate of the data of the perform arc) you can send email to miller and they send the operator manual this way you can review the operation of the cell.
Manuals about the robot can it ask to panasonic robot, by internet is really hard,
regards
-
Hello, if your robot is for sculpt, so the deviation program is created with any program offline like powermill or sprutcam?
if your answer is yes, probably your problem is the tcp calibration, you need calibrate 2 tools (1 long and 1 short) thats because you need the exactly orientation in angles.
i hope this help you in your problem
best regards
-
THANKS A LOT FINALLY CAN SOLVED WITH I START. BUT WITH BACKUP THE ROBOT LOST THE ARCWARE BUT WE HAVE COPY OF SECURITY AND WITH THAT ARCWARE OK
-
Thanks for your reply. How can do that?
My flexpendant cannot init. Is there any proccess for make that like stop botton and 1 bottom.
Best regards
-
Hello please can you help me with the manuals for controller gII the robot is ya-1 ar6. Please
My mail is *** removed by moderator ***
Best regards
-
Thanks for the advise. I have this problem.
I have modified the file moc. Can you tell me how can make the restore please. Because i can see in robotstudio the files but not init the flexpendant for make the restore
Best regards
-
Maybe is late for you but now had the same problem. I found fuse broken in a board inside of the welder.
Best regards
-
thanks a lot for the manual
-
Thanks for your reply the model is arcmate 120iL
Best regards