you need make a specific point
Posts by jmpr
-
-
Hello
Look at this manual (is for nx100 but is the same alarm)
-
you can recover the position moving only one axis (+ or -)?
if you can recover the position means that axis fault if you can not recover you have to see if the piece is always the same place and if not force welding cables gun
the last test is to remove the gun and Anticollision and put a tip on the axis t. After you make a program out of the workplace as cleaning and checking
-
This alarm occurs when one of the two fans is over the cpu fails
These fans (Brushless DC Minebea 2410ML-05W-B70) have 24v, 0v and a detector which gives an output to indicate it works and is what causes the alarm
-
What is your system? (erc, mrc, xrc, nx100, dx100)
-
Hello
this alarm occurs when process is not completed within segment clock
Increase (add more 4) segment clock s1d258
-
If you set in param you turn on in outline. In outline you can see the alarm
-
Hello
If you set the selector down in cp11 board your boot in outline and you can see the alarm
-
You need to put the compact flash with teach pendant software
If you do not have the software please tell me the version of software that you have in the cpu and your email and I will try to help you -
that's the problem, I do not get to have the instruction cvque.
I have not menus in robot menu (yes conveyor, no shift)
-
Hello
look at this manual I hope you serve
-
Hello minimann
Thanks for your answer
I'm from Spain.
I have installed the board I JANCD-XSL02 and JANCD-XCP02B.
Conveyor tracking hardware is the same as the conveyor tracking with shift function?
I think it's the same.
I think I need the software version X7.13A (us) -29 or X7.34a (us) -29 are special versions for the application of paint but I'm not going to paint
Motoman uses parameters for optional functions but in this case no, because I've tried to change them
The parameter FD106: Conveyor tracking (shift function) 1: enable
regards
-
Hello
I have installed the converyor tracking board and I configured and it works well.
But I do not know what do to shift function menu.
I have a European xrc up6 and xrc sv3 original. I test it in both
I changed the software several times (X5.29A (US-S) -00. X5.2FA (US_ES) -00 X6.57A (U.S.) -00 X5.70A (US-S) -15) each with its own file cnvyr.rom
I have changed parameters (FD20, mfxg4, s2c324, s4c515, FD113, fd116, fd106, s2c157)
I have the extended language and yaskawa mode
I get no instruction queue
The manual does not explain anything
How I can make conveyor tracking with shift function?Thanks