The robot is back in production.
I did init start tried loading an image and that's where it stopped.
did it about a dozen more times then it worked.
I'm not sure what the problem was.
The robot is back in production.
I did init start tried loading an image and that's where it stopped.
did it about a dozen more times then it worked.
I'm not sure what the problem was.
Thanks will give it a try.
looking for some help trouble shooting a DCS fault. just getting ext estop from plc.
Controller = R30ib
I have a aux axis for a turn table it looks like a its a joint speed check issue,the current speed seems to be fluctuating when not moving.
I have tried changing the encoder with no luck.
Maybe the amp or a cable I'm looking for help narrowing this issue down
You're going to want to look in your controllers electrical maintenance manual. Go to the Troubleshooting section. Then find the LED Troubleshooting area, start with the Main Board indicators. You can see which step it is getting hung up on in the bootup & you can troubleshoot further from there.
ya did all that, replaced FROM/SRAM module same issue. then replaced main cpu board same issue. Any other thoughts?
Have a robot which will not finish boot cycle. Tried teach pendant and cable still nothing. Any help would be greatly appreciated.