Ok, and this wont effect the current user frame. What i mean is the frame itself is not effected so i wont have to reframe. I would have to change all 6 axis if it where to lose it.
Posts by NovaFlatline
-
-
Update, i now know how to trigger a macro to use a program. With that said, im still lost with the homeing program. I take the LPOS, keep the Z, uh and im lost.
I load the position data, add 50 MM to Z+ to come off my work piece?
How about if i were to create a point two meters above and hope for the best. Im only using a 4" X 1/2" router bit. -
Find the manual. Ok.
-
Can you wirte karel from TP? Kinda lost here, my apologies.
-
I am self taught on fanuc controller, looking for a way to send the robot home on a pushbutton. I would like to use "user 2" button on the controller. If the fence is opened the robot goes to controled stop mode, but say an operator loads the part wrong and starts program then notices it. Is there a way that i can program the robot to "Z+" say 50 MM and return to a "home" position? What would be the steps to do so. Also i have UI 1,2,3,8 set to rack 35 slot 1 start 1 (on) would using the "user 2" be defeated by that said setup?
-
Reset now works, however new problem SRVO-037 IMSTP input do I need those to be mapped to something?
-
-
DI's are not mapped. How do I map them. Again forgive me, as I am self taught on this controller.
DI 01: when I veiw it from the I/O screen, I can see it go on and off when I push the button.
I can view the UI as well. I am confused on how to call them, or map them to each other.
-
Digital input and output cards located inside the controller that fanuc provided. example DI 1is my push button. How do I map the DI 01 to UI 05.
-
I am using supplied 24 Vdc positive and negative wired appropriately.i have the push button wired directly to the plc rack in the controller. I do not know how to map the plc input to the UI 05.
-
I'm new to fanuc, new to maintenance position. I have the ability to learn quickly. Forgive me if my terminology is off. I learned how to setup and program a rj3b controller connected to a r2000 165f
I'm having trouble with reseting the fence fault. That is generated by openimg the fence. I figured out to to simultaneously trigger both the chains so I don't get the chain fault. My problem is that I can not reset the controller with a push button wired to a input on the supplied plc rack.
What is the correct "mapping" or "wiring" that I would have to follow to remotely reset the fault?