yes i replaced the safety latch on the door
Posts by cameronsjunk15
-
-
So i replaced the door interlock. i had mottoman tell my maintenance guy how to check the pills and still no good. its getting to be a problem. its on an NX, any ideas on this?
-
is it home position 2? anyone ?
-
i cant remember which program you run then line the axis's up and set that as the new data on the xrc my brain is burnt out of late. i just cant remember it at all
-
why not try adding an if statements that if byte 23 or whatever you choose is on it will activate jumps you have in the program so all that happens is it activates and lets out your sealant. its not hard to do and if you dont have the byte in it will run like normal.
-
I will probably have to do it that way. I just did not want to do it that way if it could be helped.
-
i know i can clear out some by deleting unneeded programming problem is they built all these jobs with tons subs. fact is the gentlemen i took over from was looking at a program i built , paralell start of R1-S1 and the other as R2 with everything in one main programming using T-syncs and all but was told that im wrong for that and i have to build it as 30 subs with table turns.
-
ive just ran out of room to program, had to start deleting programs sadly and this doesnt have a ton of programs
-
i was told you can put in a compact flash drive. if not does anyone else have ideas? i called motoman and didnt get much for help sadly. which is rare from motoman
-
im 99% sure our system only have a 1gb. I have never put in a new card or the exp ordering properly what i need. can you pretty please help?
-
i hate trying to find the manuals at the site, and if you call in they tell you to go to the site. fanuc gives me better support then that and i hate fanuc
-
I plan on calling in fanuc for it, i just need to set a time line and everything, my biggest problem is my fanuc only runs 2.5-3 weeks a month on one shift. so im trying to figure out when to have them pm based off of that.
-
im new to fanuc robots. i have tons of exp with yaskawa but i digress. how many service hours do you go before grease change and etc and could you give detailed explanation on how its done? last guy who worked here before me made all the books disappear for all the robots.
-
I have changed grease for the robots tons of times but my manual is gone and i cant remember how many hours to let it go before next grease change. please help
-
what do you mean?do you mean what will weaving do for and to a weld or do you mean if you change settings in the weave file how it affects the weave?
-
its a miller auto excess 450 to an nx controller
-
im changing a power supply on a cell later this week. its the same type of power supply and all. is there anything in particular i need to do?
-
-
-