The way our system is set-up the program select method will not work. How would I go about doing this in BG logic. I apologize I am not to familiar with this type of thing.
Posts by Nickm.
-
-
I'll do my best to explain the situation. We have a 2000ib with a 30ib controller. A lot of troubleshooting is done in step as we are usually in the cell with the robot. That in itself, is usually not the problem, the problem is when we have people who may need to move the robot and they leave it in step. When we come in after a weekend off and try to start up production we can't because of this. It usually only cost us a couple of minutes but we would like to eliminate this problem entirely. Is there a way that once you take the robot from T1 or T2 to auto that it will automatically switch out of step mode? TIA
-
Hey guys, I recently went and added comments to all of our DI and DO and also our registers on one of our robots. We do not have access to Robo-guide so adding these comments was a pain. I am curious as to if there is a way to do a backup on one of our robots and then download just the comments to each of our other robots as our comments are "universal" for all of them. Any information on how to do this and if this is even possible would be greatly appreciated. Also this is a 30ib controller.
-
Unfortunately I am still having issues. Here is a picture of where I am at.
-
Hey guys, just recently my employer asked us to enable auto-back up on our 2000-ib robots. We use 30-ib controllers. It seems that I have all the settings correct for it to back up every 7 days but it seems to be backing up every day instead. Is there a setting somewhere else I need to change? Any help would be appreciated.