Erm…. did you use callproc function?
CallProc doTheMagic()
END
Do remember to reboot your controller once you have loaded the USRPROC
Erm…. did you use callproc function?
CallProc doTheMagic()
END
Do remember to reboot your controller once you have loaded the USRPROC
Hi was browsing around and saw this and tried myself, I encountered an error when the delay was at where you typed.
I tried the following
increase delay to 1 from current 0.5 - works fine
moved your delay 0.5, to 2 lines after - works fine
moved your delay 0.5, 2 lines before - problem occur
added INH after the delay - works fine
I think the problem you encountered could be that the pointer has already gone beyond while it is in the delay 0.5.
Under Monitor 2 there is a stopwatch or something.... only setback is that it only time the program lines within a single program. So if your process call a few programs you may have to add them up.
Hi Jacven, you may want to check if the sequence board is powered on. Check if you are getting 24v, if there's no 24v you may wanna check the fuse.