Hello. I have a project where I work on backups of the robot bay. me and a colleague we are creating an application with java. then we will connect the application to the network of the company .. and to our computer. and o will connect the network to the robot bay switch. my question is what we can put the application in the KPC to save automatic in the network?
Posts by El masters
-
-
The problem was in the welding transformer resistance. It sends signals that the transformer temperature is high in the transformer
-
Bosch it's good they don't have .any problem .the the problems it's only between gun and robot
-
It's in of robot when I returned to the mnemonic input / output I find disabled ..
-
Kuka Servo gun Techonolgy
-
It is a kss software 8.3 with a welding timer bosch roxtroth psi 6000
-
Hello recently we have a problem. Robot lock kuka kr c4. At the point of welding. The gun closes but the current does not pass. After we have an error message in the kcp. (Welding command fault signal input 1189. repeat point .. I check the clamp wiring all is OK .. where it comes from the problem