Dear Robodoc,
Thanks for your message, I agree with you, I bought this EA1400N and he was working with 2 robots. About contact with the Motoman Brazil, we are esperando um orçamento their.
but,
how can I test only 1 theft by disabling this second?
Dear Robodoc,
Thanks for your message, I agree with you, I bought this EA1400N and he was working with 2 robots. About contact with the Motoman Brazil, we are esperando um orçamento their.
but,
how can I test only 1 theft by disabling this second?
Dear friends,
I am in Brazil and I acquired a Motoman EA1400N to develop a personal project. I am a basic programmer and I am seeking knowledge on the YASKAWA platform. I registered on the site to receive the ROBOT app (for evaluation), but I did more than 5 days and did not get a return.
Well, you get the EA1400N only the NX100 and Robo 1, according to I evaluated it had Robo 2 and the soldering station. I was able to update with the help of a friend, but this new error appeared (Error 51), could someone give a tip?
Regards
Mano Bnu
Everson,Como estamos no Brasil,escrevo em Português me manda um e-mail.
rafael.felipe.schroer@gmail.comJô passei por uma situação parecida.
Valeu Rafael,
Falamos sim
Greetings ManoBnu,
I ran into a similar issue with my NX100 controller. This was early on in my experience with Motoman and I had replaced the JZNC-NIF board without initializing it.Try booting into maintenance mode and check if there are any new boards that may need to be initialized.
Hope that helps,
Thanks roboman32,
I sent too a email to Motoman Brazil and they informed me that I need to request a technical service and after the visit request the matrix password and update, but the cost becomes unfeasible at this moment
And now?
Dear friends,
I bought a Motoman SSA2000 /NX100 /teach pendant .... to make a new project ... but i have a little but unknown problem.
I found a friend with the same problem.
Someone can help me
Regards
Everson Santos - Brazil