To save memory on the md device. If possible, it would be a larger and cheaper storage option.
Posts by machida
-
-
Can I access a usb drive plugged into the teach pendent using ftp from a computer?
-
Hi All,
We are considering buying RoboGuide but I wanted to download the trial and demo it to my boss. Does anybody have the link? Or do I need to contact Fanuc? Thanks -
I just network all of our robots to our lan. Now the question is coming up, can we edit the tp programs remotely. I just saw this post. Does anybody know how much robo guide cost? Wanted a rough estimate before I took it to the boss. Thanks
-
So we figured out the problem. If you leave a usb drive in the robot during reboots, it takes a lot longer. Sigh. Thanks for the help.
-
So I figured out how to get to the controlled start and cold start. I did this on both robots. It took about an hour each the first time I did the cold start. It helped the reboot time a little. It now takes 9min each to reboot. Thats better than 20 min. But prior to this issue, it only took about 1 min to reboot. I'm not sure what else it can be.
-
I apologize, I’m pretty new to the Fanuc’s.
You wrote “Controlled Start (prev & next key start), which might take a very long time in your case, followed by a Cold Start (FCTN- Start (Cold))”.
When you say “start” are you referring to the cycle start button or the power? Thanks -
I have a R-J3iC. I took the pendant from another robot with the same board. Now both robots are taking 20min to boot up. Before I did the swap, only one robot had this issue.
-
Hi Everyone,
I have been troubleshooting this problem for almost a week. I have a Fanuc M-16iB/20. Every time it gets shutdown it takes almost 20 min before it boots into the OS. It goes into the pendant's bios right away. Then it just stays there. Finally after 20 min it will go into the OS. It looks like it having problems during the handshake. I've re seated everything. Thanks in advanced to everyone for their help. -
Hi,
Can anybody help me with this ftp problem? I can access the robot via http. It looks like I can log into the robot through ftp. However, I can see the directory on the robot or upload programs. I have a R-30iB board. Below is the log file. ThanksStatus: Logged in
Status: Retrieving directory listing...
Command: PWD
Response: 257 "md:\" is current directory.
Error: Failed to parse returned path.
Error: Failed to retrieve directory listing -
I have a Fanuc System R-30iB
M-710iC. Thanks -
I have a Fanuc M-710ic with a r-30IB board. I cant figure out how to configure the robot to accept a static ip. My goal is to view the programs on the memory device from my computer. Can I do thanks? Thanks for you help.