Parkash.
can you explain details about smart pad?
i have KRC2 robot
Parkash.
can you explain details about smart pad?
i have KRC2 robot
#1 i tried to switch in T1 still it is not moving.
what is KRF mode??
thanks
Dear friends,
I have this problem i cant move robot.
Please me
148 Message text Axis work envelope No. %1 violated
Cause -- The robot is inside a working envelope with MODE INSIDE STOP or
outside a working envelope with MODE OUTSIDE STOP
Monitor -- Cyclic.
Effect -- Path--maintaining braking, all active commands inhibited
Remedy -- Switch off axis working envelope or override work envelopemonitoring
in T1 mode and move free
How can i switch off axis working envelope.
Thanks in advance
i tried to make a cold start nothing changed still the same problem.
wheather it is possible to make factory restore in robot so that i can try from start to look it again?
move enable input (1025) not allowed
S is green
I is green
R not
safety is not ok then ot will not start submit interupter
any other solution
Thanks
hi
krc2
automatic mode only for small movement
hello
can any one suggest me how can i start kuka robot automatic without any external device is connected
all safety circuit is ok
i have switch the key to automatic and pressed start button its not moving
need help
Dear friends,
i have encountered a problem with kuka panel Board Terminal X11.
which is connected at bottom of panel board on pin 19 color of cable is Blue(BU)White(WH).
This is terminal for External output and safety for drives.
i dont have 24vdc suppply on this terminal.
This terminal is connected to X22 of CI3-Board. terminal 20.
Dear friends,
Can anyone suggest me how to make a small KUKA program, in automatic mode?
Thanks
Dear friends,
i have encountered a problem with kuka panel Board Terminal X11.
which is connected at bottom of panel board on pin 19 color of cable is Blue(BU)White(WH).
This is terminal for External output and safety for drives.
i dont have 24vdc suppply on this terminal.
This terminal is connected to X22 of CI3-Board. terminal 20.
Hello,
i tried to start kuka it gives listed below error.
how can i over come this error, what is need to check inside panel board?????
No: Details
432 Check of maximum current for KSD 1 not possible.
250 Incorrect servo parameter KPS 1.
216 Drive error pm1 No 3001.
Afroz
hello friends,
press CTRL+ESC to open folder.
thanks
hello
how can i change path of archive files in kuka robot....
i am unable to take backup of my file.
thanks in advance
hello,
i got solution its easy just connect keyboard and press f8.
kcp started.
Hello sirs,
Its a new robot just now i connected KCP2 display it blink for a while now it is not showing any light.
how can i rectify this problem need help.
when i switch on and off power display goes black and after on it is glowing light but not clear view in which state is my kcp.
Dear friends,
can anyone tell me, which grease is use for kuka robot.