fact, i didn't try in teach mode, I did try auto mode only. (full cycle auto)
Is the button working on teach mode only ?
fact, i didn't try in teach mode, I did try auto mode only. (full cycle auto)
Is the button working on teach mode only ?
Hi
I have Dx100 and fronius welder
on teach pendant i have button wel on/off , but is not work.
Does anyone know if and when it works, or how to manage it. He may know some address, register which controls the button and LED lamps?
I found something like this: DX200_SystemTask_Manual and HW1481811.0
Are there any other manuals on this subject?
ok, I have already found the parameter to activate System i Interrupt JOB
Now I'm looking for a manual describing the behavior of the above jobs when switching PLAY / REMOTE, on/OFF servo etc.
Can someone indicate where this information will be found ?
when I change the parameter S2C ... whether it is necessary to reboot for effect ?
Is it the same in the VRC simualtors and reality ?
you can see what are the options if you have a VRC simulator and create new project and start with maintenance mode.
In maintennace mode, it starts from the Yaskawa mode (the only way to see it)
ok,
So when a man from Yaskawa comes for Robot service, he is able to do it in about 7 seconds ?!.
Does anyone know what is the approximate cost of running that in DX200 ?
I know that is paid option.
(Everyone can write, pay).
I am not asking for passwords, code etc.
I'm just asking how it's activated. (code parameter, upgrade firmawre etc)
I thought that there are people who know it or have seen the way of activation.
How are the Select System JOB , and CTRL System JOB options activated on DX100 ?
Parameters S2 ..?
or passw Y and checkbox in Maintenance mode?
or another way?
Hi everyone!
I am probing different programming possibilities of DX100 and DX200, and I think how to delete the icon CREATE NEW JOB,
Is it possible to mask it ? (delete the icon with menu)
I saw some cmos file that did not have such a icon.
Is this a matter of one parameter type eg.S2C or must be upgrade a new firmware to the robot ?