English menu would be great
Posts by pilotfromdk
-
-
I want to be able to make large 3D models with many fine features +100K lines (prefer no limit)
From what I hear here is that I need KRC2 KSS 5.6 ?Next Question:
It it possible til Upgrade my KR200/2 Krc1 to KRC2 KSS minimum KSS 5.6 ?? -
I am hoping to be able to mill 3D models via Powermill robot on my KR200/2 KRC1
How much physical RAM would you recommend?Or would it just be a better route to find a robot with a KRC2 ?
-
How much RAM is it possible to put into a KRC1
And is it possible to find "standard" RAM that works? -
Hi
Can anyone confirm (or not) if it is possible to run a Powermill-Robot generated program on a kuka KR 200/2 with a KRC1 controller?
What is the difference between KRC1 and KRC2 ?
Is it only Hardware?Regards
Borge -
Hi Martin
Thank you very much for your video
I'm working on getting a Kuka KR 200/2 KRC1 to work with Powermill 2017
I have some of it working, BUT so far I have not been abel to transfer a working file to the robot?
Will your instructions work directly on a KRC1. Or will there be any difference to get it to work?
Is it possible to get your video in full resolution (difficult to read the menu in Powermill)maybe you can upload the video on youtube?
Best Regards
Borge -
Hi
I need to master my KUKA KRC1 KR200/2
Can anybody here point me in the direction of a drawing for a diy dial gauge adapter.
Or maybe just a picture for inspirationRegards
Borge