I just got this error (SRVO 237) and I don't know how to clear it. I tried to clear it the same way you would clear SRVO 230 and it tells me that it cannot be cleared. What other steps should I take?
Posts by robot Joe
-
-
I was able to reset the chaiin fault by:
MENU / SYSTEM / TYPE / CONFIG
SCROLL TO 28 - RESET CHAIN FAILURE DETECTION: FALSE
SWITCH TO TRUE (IT SWITCHED BACK TO FALSE AFTER A SECOND OR SO)
THIS ALLOWED ME TO CLEAR THE FAULT.
thanks so much for the support.
-
I'm getting these two errors and can't figure out how to remove:
SRVO - 230 (+24V ABNORMAL)
SRVO - 231 (Ov ABNORMAL)Can anyone please help me out....thanks
-
OK...It seems to be from the twisting of the wrist. I will make some changes to the program. Thanks
-
I'm trying to run a program and keep getting this message (MOTN-063 position config change). This program has a different home position from all my other programs. Is there some type of setting I need to enable or disable to get it to work. Every time I need to run this program I have to rewrite it. It's very time consuming. I need some help.
-
Thanks for the help...I was able to clear the fault.
-
I'm trying to run a program I just created and I'm getting an error (SRVO-004 fence open). How do I clear this error?
-
My company just bought a FANUC 430Si (USED), and we just installed it, connected all the cables as they were labled, and we now have a SVO ERROR 232 NTED INPUT showing up on the screen. I do not have a manual of any kind to reference this error. Can anyone help me with this?
-
I need an operators manual for a FANUC 430-Si. Does anyone know where I can get one?