Hello,
No worries , take all the time you need !
You are already very nice to take time to help me !
I send you my email address in PM.
Thank you !
Hello,
No worries , take all the time you need !
You are already very nice to take time to help me !
I send you my email address in PM.
Thank you !
Hello !
I buy the board yesterday for SRAM PCMCIA module and a PCMCIA SRAM 2MB card.
I think there must be a solution to load the software by RS232, I will try to find the solution.
They miss me That a backup " valid " for my robot . I'll try after receiving the PCMCIA module and the PCMCIA card to make a backup and a restore , maybe her walk away !
I really thank you for your help .. I find really stupid to have to scrap a functional robot just because I lack a backup ..
I will keep you posted on the progress !
A question the Soft this finds you there on the FROM or ROM?
I have a bmon Version 02.00 and I have the function backup and restore from a memory card in the " TeachPendant " .
I can also be purchased adapter to Integrate the memory card to the CPU if it is the only solution.
There are not possible to transfer these files by the RS- 232-C Port positioned on the main console ? (I have the cord )
Or even through the RS232 port positioned directly on the CPU? ( I also have the cord / adapter)
Sincerely you help me, so I have all the time you want ..
Thank you once again !
Thank you more for your help !
Unfortunately no, I 're no disk or diskette ..
I have lots of paper documentation , but no digital file ...
I think it is just enough to restore the software but I 're not the files needed for restore.
I was not specified, the robot remained 16 years off .. But the battery of the CPU still had a can of juice ( 0.86VDC ) ..
Is it possible to take the backup of another S- 700, and restore my robot ? ( If the hardware configuration and the same course)
Thank you for the answer !
I did the manipulation, but nothing ..
I think memory (FROM) is corrupt. Let me explain.
First configuration: I start the CPU with the FROM, nothing's going on, the green LED lights well but the startup sequence seems stuck .. The "TeachPendant" remains on the screen "TeachPendant Ready".
Second configuration: I start the CPU without the FROM the "TeachPendant" says "error 36: System software not loaded"
I made "INIT" and "START", but the message "Error 36: System software not loaded" back
Third configuration: I start the CPU without the FROM and then I added in operation, I check it is properly taken into account, I use the function "DIAG" and "SHOW" FROM the memory is taken into account.
I made "INIT" and "START", the LEDs that put in the same situation as in the first configuration and nothing ..
Hello guys ! I need help
I am a big fan of robotics, there is some time I was offered a former FANUC ! The S-700, with only 1600 hours ..
I spend a lot of temp restored, and then it came time to turn it on !
All works, some little problems (emergency stop outside, coder who lost their memory)
Then TeachPendant that blocks ...
The CPU all green LED blinks and the first red light stays on fixed (RAM parity).
After several tests it turns out that all the problem comes from the FROM .. I can start the CPU without the FROM module, but when I replace the module FROM blocks the cpu ..
I buy a new FROM module on Ebay, but unfortunately I do not have the "MASTER" Robot for restored. I have the cable for the PC but here, I do not find KFloppy, and I can not find the "MASTER" ..
I contacted FANUC but it was very clear, as an individual, it will not do much for me. I really need a kind soul ..
Thank you in advance ..