Hello Skooter,
I tried a new cable on them both, and they still don't come up. Yes, they both pass self-test.
Thanks!
Hello Skooter,
I tried a new cable on them both, and they still don't come up. Yes, they both pass self-test.
Thanks!
Hello Iowan
Another pendant I have besides those 2, boots up fine,, no problem. So it may not be the Image file since another pendant, with the same software version, works fine.
any other suggestions?
thank you much.
Hello ebb,
it is a IRB6400R.
Hello.
I have 2 ABB TPU2 Teach pendants, Model # 3HNE 00313-1, and they both say: "Start up in progress". They never go to the main home screen, yes, they are plugged into the controller, which is an ABB IRB6400. I have tried a new cable on both of them, and no luck. Does anyone know what to check,, etc,, for the problem? What i am able to check on the pendant itself, seems fine.
Any help would be appreciated!!!
Hello.
I have a Fanuc Teach Pendant, Model # A05B-2490-C172, and when I plug it in the RJ3 controller and turn the switch in the 'on' position with the deadman switch engaged, the pendant says 'Deadman Released'. It is not released. It says it no matter what switch is engaged. I checked the switches with my ohm meter, and they are fine. Any suggestions???
Thx!
Hello All!
I have a Nachi AW controller and robot. I have the power going in it, the switch is on, but i have no lights, no nothing, on/in the controller. My fuses check fine.
Any ideas of what to check/test/ etc?
Thank you DaveP!
One of the contacts on the E-Stop Switch was bad!
Thx again!
Thx! I will check this.
What is a "Chain 1 Fault +24 Volt" error, and how do you fix it?