Ok. Thanks
But where is this function in PP? now, i don't see this function in PP. How can i active it?
Posts by TSGIR
-
-
I couldn't enable in adapter. can you help me?
-
Hi
I have Dx200 controller. I want to use this controller and MH12 robot for Arc application. in manual i see about "Teaching line coordinates (arc welding purpose)" . What is it? How can i use from this operation coordinate system? Can i educate to robot the arc application without jog axis with PP? -
No i don't have Motosight.I have insight software. can i connect vision and Dx200 with this software?
if you have any manuals about communication and robot program please send me. i don't know how can i write program for robot and do pick and place application please help me. -
4. and also, how can i see vision view on the programming pendent?
-
hello
I have a Dx200 controller and i want to connect it to cognex insight 5000. i have some question:
1. Can i connect vision to Ethernet port in CPU? What is the setting for cognex and DX200?
2. Do you have any document and example about it?
3. How can i send and receive data between controller and vision? -
and also, i couldn't connect to controller with Ethernet ip.
-
I have same problem,too.
-
Hi
I have a controller with type CR9-513-S22 and two robot with type RV-15AP-S02. I have Bat alarm in controller and i change battery but after that i lose connection between controller and software for data. What is the problem?
also, i want to connect the controller with Ethernet (ip: 192.168.0.1) but i couldn't it. i check my connection with another controller and i can connect to my PC. -
Thank you
-
High level code?
What is it? can you give me list of it? -
Thanks
No there aren't another robot. can you tell me what is the port number and which board? -
Therefor i need specially code for external axis.is it right?
-
We have MOTOWELD-S350. From your information i think this alarm is for ARCON signal that send and receive between controller and power source. is it right or there are another matter?
-
hi
I have DX200 controller and one 6 axis robot. I want to connect two axis to this controller. can you help me? have you any document about it? -
Thank you
Do you have any document or manual about IP connection for example with plc and vision system? -
Thank you for your information.
Our robot do arc for 1 sec and after that we have this alarm. can you give me a document about connection and signals between controller and power source? -
Hi
I have Dx200 and MH12. My controller fixed in Arc Welding for Application. How can i change it to another application? (for example: Arc spot or general ,...)
Thanks -
Please help me about Ethernet/Ip config for Dx 200. I can't active my Ethernet/Ip ( cpu board) in setup. what is the matter?
Thank you
-
The text in PP is "Missing arc generation confirm".