Thanks, I will try it. Is anywhere publicly available source, where do you get this command?
Posts by safix
-
-
yes, servo axes.
-
I thought it just teoretically, if it is possible...
Maybe I told it badly. I meant the temperature of the engines of robot axes... -
Thank you,
yes I've tried to measure that temperature (via $PHGTEMP) on krc4 and it showed me nothing ("0"). Finally, I know the reason...Thanks Skyefire and panic mode as well!
Do you think there is a way to measure the temperature of the engines inside the robot kuka krc4? -
Hi,
i've read a document that I am able to measure the temperature inside the KCP through a specific instruction. Please, can you tell me where exactly is that sensor in KCP? What does KCP mean exactly? I found that it is the interface to the robot controller and to the robot (http://www.wtech.com.tw/public/downloa…ontrolpanel.pdf) , but the abbreviation is kuka control panel(i thought it is a smartpad). Thanks for the explanation. -
Thank you,
do you know which ones are better in terms of energy consumption?
-
Hello,
I would like to ask you about the topic " Servo motor robotic welding guns and Servo pneumatic robotic welding guns ". Do you know someone what are the advantages and disadvantages? Thank you. -
I set ESM (configuration)...robot moves to default position and suddenly it shows on the display pause notice and program has stopped...
just hand guidance isn't working ..(I set all by the manual)
I don't know where is the error. Thank you. -
It was, but it doesn't matter..thank you
Do you have any experience with robot kuka lbr iiwa (for example hand guidance) or something? -
Yes, you are right, it's the solution
-
Well, but I can't find how to remove this error with ESM...Do you have any experience with this robot?
-
Hello,
how can I configure or activate hand guidance on Kuka Lbr_iiwa_7? It shows me an error with ESM state, vide attachment. Thank you. -
Hi guys,
I would like to ask you, how can i solve this problem: I installed virtualbox with windows 7...Firstly, I installed workvisual 3.0 and then I've tried SunriseWorkbench-1.7.2.14KMR...but at the end of the installation it showed me this(attachment)...I tried restarting the PC...but it's still not working... I don't know what more can i do? Thank you for your help/replies.
-
Aw, It's a drag Do you think there will be the support for win8 sometimes? Thx
-
Hello, can you help me with this problem?
I already installed WorkVisual 3.0..It did well...but, I can't install Sunrise Workbench... I have windows 8.1. Is it possible to install for this version? In progress it showed me this notice (attachment). Thank for your reply.