I tried different pm600 but the problem is the same. What could be the problem?
Posts by aytac balaban
-
-
Hi everyone,
I have a Krc1 controller.When I plug in the x202 socket at pm6-600, the F1 10amp fuse in pm6-600 breaks down and the batteries do not start when the power off. I tried with different pm6-600,the problem continued.What could be the problem?
-
Thank you for helping but,
I solved the problem, the problem was that the x1, x2, x5, x6 socket screws were not fully tightened. -
Hi everyone,
I have ırc5 controller ırb 2400 manupulator.Manupulator is working I tested in another controller , this controller working in automatic mode but when I press enabling switch in manual mode ( Enabling device conflict ) comes.I replaced ( f.pendant.panel unit contactor board,axis computer,f.pendant connection cable,motor on and brake contactors,mode section switch) but problem is not solved.How can I solve this error.
-
I replaced motor on contactors ,robot working in automatic mode now but when I press enabling switch 'enabling device conflict' in manual mode and not moving
-
Yes,I installed a flat system with no features
-
The upper cabin is for the second robot but I only use the lower cabin
-
I changed motor on contactors, when I press motor on button costactors are activated in automatic mode but 'joint collision' error cames.when I press enabling switch in the f.pendant 'enabling device conflict 'error.I will try new system build tomorrow.Do you have any idea?
-
I change main computer problem is not solve.No error in manual mode, there are errors in the picture in automatic mode
-
Yes,Ihave. I will change and write the result
-
I replaced the cable beetwen the (contactor board-axis computer),(main computer-panel unit),(flexpendant-main computer)but problem is continues.
-
I shared status light is not on.When I put the robot in automatic mode comes error 20312 enable 2 open.
-
I tried, but the problem continues.Do you have any other ideas?
-
Hello all,
I have a Irc5 M2004 dual cabinet.When I press enabling switch(20312) enable 2 open error comes.What may be problem?
Thank you for answer
-
Hello all,
I have a Irc5 M2004 dual cabinet.When I press enabling switch doesn't have any error but no contactor activeted.What may be problem?
Thank you for answer
-
I haven't tried, could the problem be transformer?This controller of ırb 6600,I changed the drive power cables and now I want to use it in 4400 but ı have this error.
-
Transformer input voltage 3×230V AC.I checked transformer input and output voltages,values are normal.
-
Hello,
I have s4c+ controller and ırb 4400 manipulator.
I am new preparing this robot. My problem is , when ı pressing motor-on button 3sec. after, error bleeder overload 38501.
I change it bleeder resistor and current limit resistor but problem not unresolved.How can ı solve this problem?
-
Yes I got the hdd backup
-
Hi,
If you have spare parts try to change,
KPS600
ESC Board
MFC Card or
KCP