Hi rzapo thankyou for your reply we are in Australia
Posts by Stan t
-
-
Hi all , Got a slight problem with alarm 200 RC conform Parameter , Unit not used for nearly 18 mth and when powered up gives this error and cannot go any further. Your help would be Greatly Appreciated Regards Stan t
-
From Stan t . Just want to Thank Very much Robodoc ( Should change name to RoboExpert) After joining Forum 4 weeks ago , got a few suggestions as to servo tracking problem from some off you guys,(thankyou anyway) but unable to solve fault.
Robodoc Was able to pin point fault after a few emails back and forward,. Note: Could not even get Yasnac local agents to even respond SK16 not on there books ? We are in Australia and Robo Expert (New name by us anyway) in Canada , Solved our problem when doing what he suggested
Thankyou Once Again Robodoc/Roboexpert thankyou Stan t -
Requesting Engineering manual to try to sort out error 1380, Have been onto united states Agents wanting to purchase $ but no reply to date
-
Hi Thankyou for previous reply. Error code 1380 Servo Tracking SLURBT Robot 1
Have got Password for ORG but numbers on Set and on Orig totaly different, tried changing and has not fixed Error, I guess that i am not ressetting correctly. Have got Original SLURBT set up Numbers for home position , Your help would be Great . New to this Forum 2nd Question posted hope i am doing it correct way
Stan t 8/8/13 -
Hi all only just joined up;
hope get my question across correctly. Quest 1 Alarm error 1380 - Servo tracking error robot 1, How do i fix. Quest 2 - R1 joint continually across display on programming hand set, and this wont allow me to teach new job ,
Your help would be greatly appreciated Regards Stan -
Hi all new to you guys so i hope doing right way.
Have got Yasnac MRC SK16 and have 2 problems that hopefully can help , 1st been since start, Cannot teach hand held unit as when trying R1 joint continually flashes up across display, 2nd which only happened yesterday Alarm Error 1380 Servo tracking error robot 1 , SLURBT
Hope you can help Thank you Stan