I found that the speed was being set using an override instruction in several TP programs. Thanks everyone.
Posts by gdemark
-
-
When I try the: SETUP --> OVERIDE SELECT --> F4 ENABLE,
I get a message "index # is not right"
So the speed overide stays disabled.
Thanks
-
The software is: LR Handling Tool, M6.30-6. Thanks
-
I have an LR Mate 200ib. When I change the overide speed (up/down) it always defaults back to 70%. How do I stop this behavior. Do I need to set up a system variable at start up? Or do you suspect there is a sub that is setting a speed variable.
Thanks very much
-
How can I save a TP program in a format that I can open up in a text editor on my laptop? Thanks
-
I am a relatively new at working with Fanuc Robots (LR Mate 200iC). When I went to remark a line I was expecting to see an exclamation mark to start the line. Instead, forward slashes were displayed (//). Did I do something wrong or are // a valid remark line designation? Thanks